There are many generic olanzapine orodispersible formulations, but their relative disintegration and dispersion times have never been studied to our knowledge. Variation in dispersion times might

be expected, depending on the different fast dissolve/disintegration technologies used to manufacture the tablets and/or the disintegration test used to evaluate them. Olanzapine Zydis® (also known as Velotab®) is manufactured by Catalent Pharma Solutions (Somerset, NJ, USA), and is made by a freeze drying process that provides a low-density, highly porous structure that readily Buparlisib concentration disintegrates in the oral cavity. Although bioequivalence is accepted for generic ODTs, the time it takes for an ODT to disintegrate and dissolve in the oral cavity may potentially impact clinical parameters such as patient acceptance and adherence to treatment. For olanzapine Zydis® ODT, the elapsed time for

initial and complete disintegration was measured in two small in vivo studies [14, 15]. However, these studies used different methods: one took the first measurement of initial disintegration at 15 s, while the other took the first measurement CB-5083 manufacturer at 5 s. It is desirable to compare disintegration times among different products using the same methodology. Given the obvious challenges of standardizing in vivo assessments, the objective of our current in vitro comparison was to investigate in vitro disintegration time and dissolution rate differences of various generic formulations of olanzapine ODT relative to olanzapine Zydis® in simulated saliva. We also compared the chemical and physical properties of each ODT and measured in vitro disintegration time for risperidone ODT [16] as a comparator. 2 BAY 1895344 manufacturer Materials and Methods All types of olanzapine ODT that could be obtained were evaluated (Table 1). Eleven different examples were filmed to determine disintegration times, and all were evaluated for manufacturing method, dissolution characteristics and formulation differences,

including the freeze dried Zydis® formulation of olanzapine ODT and Paclitaxel risperidone ODT. A Canon XHL1 HD camera (Canon, Tokyo, Japan) was used to capture a 3-min disintegration event for each ODT product added to 30 mL of non-agitated 37 °C (initial temperature) simulated saliva solution in a 10-cm Petri dish. Disintegration was defined as the time it took a tablet to reach full dispersion after addition to the artificial saliva (see Table 2 for the formulation, based on formulations described in Giannola et al. [17] and Gal et al. [18]). Drug product excipient data were obtained from published product literature. Dose form and manufacturing method (compressed tablet, lyophilized wafer) were determined by microscopic/visual observation.